Heater heating (external heat): At present, plastic extruder uses electric heating, which is clean, effective and easy to control heating method. That is, an electric heater (with resistance wire inside) is packed on the barrel, and heat is generated by electricity. Due to the combined effect of heat conduction, convection and radiation, the material is heated and melted. Current heaters usually include mica heaters, ceramic heaters, cast aluminum heaters, cast copper heaters, cast iron heaters, etc. There are some differences in the effectiveness of various heaters. Mica heaters have low cost and are easy to process. The service life is short; the power of ceramic heaters and cast iron heaters is large, the temperature rises quickly, it can rise above 300 ° C or higher, the life is relatively short, and it is longer than mica heaters. Cast aluminum heaters and cast copper heaters are the most commonly used due to their high thermal efficiency, good thermal insulation performance and long service life.
Skjær friksjonsvarme (indre varme) i ekstruderingsprosessen til plastekstruder: Under ekstruderingsprosessen genereres varmen ved deformasjonen av formen til plastpartiklene på grunn av det sterke ekstruderingstrykket, mellom plastpartiklene og mellom partiklene og fat Og friksjon på grunn av friksjon. Under oppvarmingsprosessen øker tregheten til temperatur, uansett hvilken oppvarmingsmetode som brukes for å stoppe oppvarmingen under oppvarmingsprosessen, fordi temperaturen stiger, vil temperaturen fortsette å stige. På dette tidspunktet må du se på kontrollparametrene og nøyaktigheten til temperaturkontrollinstrumentet. Skjær friksjonsvarme (indre varme) i prosess med plastekstrudering. Den indre varme som genereres øker prosesseringstemperaturen kontinuerlig, ødelegger egenskapene til materialet og får materialet til å bli et avfallsprodukt.